Skip to content Skip to sidebar Skip to footer

Widget HTML #1

Ford F150 Throttle Body Reset


Ford F150 Throttle Body Reset. Erase the diagnostic trouble code (dtc) with the scan tool using the“delete” or“erase” command. You’ll find a red clip.

20112016 Ford F150 EcoBoost V6 3.5L Silver Bullet Throttle Body
20112016 Ford F150 EcoBoost V6 3.5L Silver Bullet Throttle Body from www.octanemotorsports.com

Rough shifting can be indicative that further issues are likely with the throttle body. >3) with the truck in neutral, run the engine at 2500 rpm for 30 seconds. You’ll notice four bolts on the throttle body which hold it.

Rough Shifting Can Be Indicative That Further Issues Are Likely With The Throttle Body.


Start the engine and let it run until it reaches operating temperatures, then turn off the engine and let it idle. In order to access it, you will need to remove the air intake ducting that is in front of it. Allow drainage of backup power and reset the power terrain module.

Your F150’S Throttle Body Controls The Amount Of Air That Enters The Engine.


After that, we have cleaned the upper areas of the battery in the truck. Wait 7 seconds, and hold the accelerator down. Reconnect the negative battery cable, and then turn the key on and wait 10 seconds before restarting your truck.

After Exposing Your Throttle Body, You Will Want To Spray The Cleaner Inside Of The Air Ducts.


Next, uplift the hood and detach the negative battery terminal. If you’ve replaced your ford electronic throttle body or you’ve disconnected the battery, you must do a ford throttle body relearn to establish a new baseline idle. Remove the throttle position sensor.

The Check Engine Light Should Start Blinking, Continue To Hold Pedal Down Until It Stops Blinking.


Got errors for throttle body and replaced. While this isn’t often dangerous, it can be uncomfortable for the driver. Starting in early 2000’s, many car makers including ford started installing fly by wire electronic throttle bodies.

You Control The Throttle Body Position With The Gas Pedal.


Reset the “tp learning value”. Disconnect the idle speed control (isc) solenoid. Push all the way outward using a screwdriver.


Post a Comment for "Ford F150 Throttle Body Reset"